RXS, fitting a different rear wheel.

0415image000

But first, why is this tire bigger then the engine?

0415image001

Had to let the air out again to fit the wheel.

0415image002

the loncin honda 50 (110) is pretty much finished won’t have any light (no coil for it) and the gearing needs changing, it’s very revvy at 30mph

0415image003

Right, here i have finished filing open the swingarm to accept the larger axle.

0415image004

then i tired drilling out the holes in the rxs sprocket to fit the gs rear hub, stuff was way too tough, finally did it with a round file, although it’s not very accurate, it will do until i can afford a new custom one to fit.

0415image005

Used my flat edge thing that i use for putting in engines, and measured thickness of the rim the offset of the edge of the rim to the sprocket face, from the sprocket face to the outer side of the spacer.

0415image006

found out the center of the rim, and figure that i needed to move the gs rim over by 3mm (100.5mm to 97.5mm) also the sprocket needed moving in by 6mm

0415image008

Well got that done in no time, just have to machine 3mm off the spacer and that moved the wheel over, the worst problem right here with taking metal off the sprocket carrier is that the sprocket is no longer aligned with the bearing, i may find a 6mm wider bearing to fit in, it also may cause no trouble at all, but the bearings were fairly seized in the first place so i expect some failure anyway.

0415image007

Next the boring job of painting and hole fixing, i am amazed this thing kept any petrol in it at all.

0417image002

That took a lot longer to do then to put up these two images. Filling the dents and holes will take even longer 🙁

0417image000

Back to the rear end, wheel all in now, made up the spacer on the right myself with a file and hacksaw it did not need to be as accurate as the left spacer.

0417image001

Had to beat the old chain adjuster straight(er) to avoid touching the carrier (despite take 3mm off that as well)

0417image003

Now with the tank in silver and most of the wheels, might i go with silver all over? was talking the other day and changed my mind again about the black/yellow idea for the wheels think i should do them a dark almost bronze gold now. Dunno.

Leave a Reply

XHTML: You can use these tags:
<a href="" title=""> <abbr title=""> <acronym title=""> <b> <blockquote cite=""> <cite> <code> <del datetime=""> <em> <i> <q cite=""> <s> <strike> <strong>