Runner 180 kart airbox

Made a thick adaptor to fit the airbox’s filter

Then with some fiddling about it’s pretty close to fitting, still had to use the heat gun to get some clearance around the rear tyre and a little bit more around the shock for good measure too.

Cardboard mock up of the brace, didn’t get any photos of it done in steel, needs another bit to give it full strength. Nice spot to put the number plate if i get rid of the rear splash guard. It looks a bit too wide but it goes no further then the passenger peg or the kick start.

The mudguard that was attached to the engine is gone, can’t be bothered cutting it up to suit, and it does feck all anyway

As you can see in the last pic, it should fit with out body mods, and it sounds perfect,just a hint of induction roar, will have to get the new job done, get the body work on and go for a proper test ride.

i can just get to the kickstart, mines modded to be a bit higher, but now i have a working choke with the oko so a standard lever would be ok now.

Tags:

Leave a Reply

XHTML: You can use these tags:
<a href="" title=""> <abbr title=""> <acronym title=""> <b> <blockquote cite=""> <cite> <code> <del datetime=""> <em> <i> <q cite=""> <s> <strike> <strong>